Field Campaign Organization

This page is a repository of information about how to organize a field campaign.

• Before the campaign starts
  • Create an email list for communication about the study. Make sure it is spam-protected (e.g. only people subscribed to it can send emails to it) as otherwise it may not be useful.
  • Create a Wiki page for the Scientific and Logistical information for the study. ([ DAURE examples: science and logistics)
  • Create a Google Spreadsheet with the dates in which different people will participate and their contact info ([ DAURE example])
  • Establish a data format (DAURE example)
  • Propose a policy for sharing data and circulate it among the campaign participants (DAURE example)
  • Create an SFTP server for uploading both preliminary and post-campaign data (DAURE example).
  • Ask people to install the software needed to access an SFTP site: e.g. WinSCP for windows and Cyberduck for Mac
  • Get internet connection of sufficient speed at the sites
  • Make a budget of the power needed and compare with the available power
  • Ask campaign participants to measure the power consumptions of their instruments using a Kill-a-Watt or similar device
  • Make a space budget and compare with the available space. If space is tight, create a floor plan specifying the location of the different instruments and circulate it.
  • If needed for international campaigns, get plug adaptors and/or transformers for the local power. There World Maps show the voltage and plug types used around the world.
  • Make sure to bring an AC Socket Tester and a Kill-a-Watt in your hand-luggage so that you can start testing the power outlets immediately after arrival, without having to wait for the arrival of shipments.

• When the campaign starts
  • Verify that the power outlets are wired properly with an AC socket tester
  • Verify that the voltage of the power outlets corresponds to expectations
  • Label all the outlets with their circuit number with a sharpie. This should be done before the instrumentation is installed. The simplest way is to switch off all the breakers but one, see which plugs still have power and mark them, then add a 2nd breaker etc.
  • If possible and if this information is not already known, measure the power consumption of the different pumps and instruments with a Kill-a-Watt
  • Create a power budget and post it in a prominent place at the site
  • Tape over power outlets that cannot be used because the circuits are already maxed out, and write a note of who to contact with questions about the outlet.

• When the campaign is starting to gather data
  • Remind people to start submitting data to the SFTP site and to update them every few days
  • Create a spreadsheet showing which data has been uploaded, has been acquired but not uploaded yet, and won't be available due to instrument problems DAURE example
  • Make sure the data which is starting to be submitted includes enough header information, including the time used (e.g. local, standard, UTC), the units for the m3 (STP and which definition, ambient, other) for concentrations reported ug m-3, etc.
  • Establish a schedule for science meetings (once a week worked well for DAURE, but this depends on how many sites are there and their distances etc.)
  • Start plotting all the data in "Master Plots" for each site (see Examples for DAURE). This